![]() I would really appreciate any help with this. If I were capable of applying an upward force at ( 0, 0, -0.25 ), wouldn't the box start spinning away ( into the page ) from me - and not spin clockwise? Integrated, removable breath-box-ready tabs Optional breath box, chin skirt, liner, and cheekpad sizes are available. If I were holding that box in my hand, then ( 0, 0, -0.25 ) would be on the side facing me. And the crossproduct is, so the torque is in the $x$ direction and the box should rotate clockwise? Team Z 79-04 Mustang WELDED Lower Torque Box Replacement Kit. ![]() To find the torque, we would applyĪnd so $r$ is and $F$ is. I need some advice to be able to take them out completely. We remove a lot of spot weldings and the plate that holds the torque boxes is moving, but does not comes out with the torque boxes. The $x$ axis is left(-) and right(+), the $y$ axis is up(+) and down(-), and the $z$ axis is into(+) and out of(-) the page.Ī force is applied at the point ( 0, 0, -0.25 ). we are in the process to remove the upper torque boxes to install the Team Z Torque Boxes. ![]() ![]() When we were in the process of building the boxes, Dave at Team Z, told me if we did the bolts the way he did, they would never be an issue. I have a box that's centered at ( 0, 0, 0 ) with length ( $x$ dimension ) = 1, width ( $y$ dimension ) = 0.25, and height ( $z$ dimension ) = 0.5. To address the 1/2 or 5/8 bolt controversy, the Team Z built, Brad Edwards 3.94, near 1 sec flat sixty foot was done with the 1/2 bolt and DOM sleeve/bushings exactly the way we do them. Shipping Address: Motion Raceworks 112 E Industrial St. I think I'm missing something with torques. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |